|
| Hi
Sean,I
too
have
b
|
|
 |
|
 |
Hi Sean,I too have been looking at savgaling what I have got rather than looking for new units, a wire brush has made them look much better. I managed to ease out the Master Cylinder's components with lots of tapping/banging the unit on to a block of wood and using gravity as and aid. The technique has not worked for my Slave Cylinder though, the inner piston only getting flush with the body of the unit and then no further. An air-line may be my next attempt to extract the slaves internals.I hope to try Speedy Spares near Brighton, Sussex for the cylinder repair kits, is that who you have got yours through? You may get me on RnS if you wish to share the parts list. Finances have been the restriction on this project so far.Thanks, Dom
|
 |
|
 |
|
|
|
|
|
|
(VISITOR) AUTHOR'S NAME
Putri
MESSAGE TIMESTAMP
16 december 2014, 13:13:19
AUTHOR'S IP LOGGED
62.210.78.179
|
|
|
|
